LACP is an IEEE standard for Ethernet (802.1AX-2008). Information in this document applies to any platform. RX bytes:76193 (76.1 KB) TX bytes:76193 (76.Link Aggregation Control Protocol (LACP) on Exadata TX packets:306 errors:0 dropped:0 overruns:0 carrier:0 RX packets:306 errors:0 dropped:0 overruns:0 frame:0 TX packets:63 errors:0 dropped:0 overruns:0 carrier:0 RX packets:3417 errors:0 dropped:0 overruns:1 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 UP BROADCAST SLAVE MULTICAST MTU:1500 Metric:1Įth1 Link encap:Ethernet HWaddr 12:34:56:78:9a:bc <- set using ifconfig TX packets:9444 errors:0 dropped:0 overruns:0 carrier:0 RX packets:10519 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST MASTER MULTICAST MTU:1500 Metric:1 However, I am able to use ifconfig eth1 hw ether 123456789abc to set the mac address on the adapter (works on both eth0 and eth1) bond0 Link encap:Ethernet HWaddr Syslog reports that bonding: bond0: Error: dev_set_mac_address of dev eth1 failed! However, even after it is brought up, it is not enslaved to bond0Īttempting to use ifenslave bond0 eth1 results in Master 'bond0', Slave 'eth1': Error: Enslave failed
When the system boots bond0 comes up with only eth0 as slaveĮth1 is not up at all in ifconfig but can be brought up ifconfig eth1 up The bonding configuration works in bond-mode 0 but not bond-mode 6 Bonding is in /etc/modules for automatic loading at boot
0 kommentar(er)
